OPPSUMMERING
rs274 [-p interp.so] [-t tool.tbl] [-v var-file.var] [-n 0|1|2] [-b] [-s] [-g] [ input_file [output_file] ]
BESKRIVELSE
rs274 Standalone G-code interpreter interface
Usage: rs274 [-p interp.so] [-t tool.tbl] [-v var-file.var] [-n 0|1|2] [-b] [-s] [-g] [input file [output file]]
VALGMULIGHETER
- -p
-
Specify the pluggable interpreter to use
- -t
-
Specify the .tbl (tool table) file to use
- -v
-
Specify the .var (parameter) file to use
- -n
-
Specify the continue mode:
0: continue
1: enter MDI mode
2: stop (default) - -b
-
Toggle the block delete flag (default: OFF)
- -s
-
Toggle the print stack flag (default: OFF)
- -g
-
Toggle the go (batch mode) flag (default: OFF)
- -i
-
specify the .ini file (default: no ini file)
- -T
-
call task_init()
- -l
-
specify the log_level (default: -1)
EKSEMPEL
To see the output of a loop for example we can run rs274 on the following file and see that the loop never ends. To break out of the loop use Ctrl Z. The following two files are needed to run the example.
FIXME: Some good soul please fix the whitespace for the examples below
test.ngc
#<test> = 123.352 o101 while [[#<test> MOD 60 ] NE 0] (debug,#<test>) #<test> = [#<test> + 1] 101 endwhile M2
test.tbl
T1 P1 Z0.511 D0.125 ;1/8 end mill T2 P2 Z0.1 D0.0625 ;1/16 end mill T3 P3 Z1.273 D0.201 ;#7 tap drill
command
rs274 -g test.ngc -t test.tbl
SE OGSÅ
linuxcnc(1)
Mye mer informasjon om LinuxCNC og HAL er tilgjengelig i brukerhåndbøkene for LinuxCNC og HAL, tilgjengelig i /usr/share/doc/LinuxCNC/.
FEIL
Ingen kjent for øyeblikket.
FORFATTER
This man page written by Andy Pugh, as part of the LinuxCNC project.
FEILRAPPORTERING
Report bugs at https://github.com/LinuxCNC/linuxcnc/issues.
ÅNDSVERKSRETTIGHETER
Copyright © 2020 Andy Pugh.
This is free software; see the source for copying conditions. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.