External Jogging

Hello,

on my Machine I do Jogging with external Buttons.
I select the axis with 3 Buttons and do the Signals to halui.joint.xxx.select
and the + and - Buttons goes to halui.jog.selected.plus and halui.jog.selected.minus
the pin halui.joint.selected shows 0 with x axis, 1 with y axis and 2 with z axis.
When I select x and jog than moves x-axis
When I select y then y moves.
But when I select z then y moves also and not z ?????
The halui.joint.selected shows 2
What is wrong?
Does someone have a idea?
this works under 2.5 the fault I see after update to 2.6


Best regards
Thomas

Hello John

here is my postGui.hal

With the Keyboard its OK

Hello John,
I commendet it out, and the same problem,
X and X moves

Y and Y moves

Z and Y moves.

in the AXIS Screen the Axis Jogginmg is OK

Any Ideas?

Thomas

The wirin should be OK
I have 1 + button and 1 - Button,
I have 3 buttons to switch the AXIS ( X Y Z )
And the Signal halui.joint.xxx.is-selected shows the selectes Axis, only when 2 is selected Y moves