7i43 max step freq

More
13 May 2011 20:59 #9793 by billykid
7i43 max step freq was created by billykid
someone tell me the maximum step frequency of 7i43h?
I read that is low as parallel port mode.
thanks
mauro

Please Log in or Create an account to join the conversation.

More
13 May 2011 23:36 #9796 by andypugh
Replied by andypugh on topic Re:7i43 max step freq
Something like 10MHz. Really far more than any motor can follow.

Please Log in or Create an account to join the conversation.

More
14 May 2011 03:43 #9797 by PCW
Replied by PCW on topic Re:7i43 max step freq
I think its like ClockLow/4 so 12.5 MHz with the 7I43s 50 MHz ClockLow. What_is_ slower with the 7I43 (compared to our PCI cards) is EMCs access time to the hardware registers, so servo thread rates over a few KHz are not practical with the 7I43. This is not a problem with the hardware step generator, where a 1KHz update rate is usually fine, as this means that the step _rate_ is updated at 1 KHz, with the hardware
generating the actual pulses (with up to MHz rates).

Please Log in or Create an account to join the conversation.

More
14 May 2011 08:48 #9798 by billykid
Replied by billykid on topic Re:7i43 max step freq
Thanks for the quick replies and clear.
Mauro

Please Log in or Create an account to join the conversation.

Moderators: PCWjmelson
Time to create page: 0.071 seconds
Powered by Kunena Forum