NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC Basic Configuration Limited velocity

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1
  • 2

TOPIC: Limited velocity

Re:Limited velocity 28 Июл 2012 04:06 #22553

  • BigJohnT
  • BigJohnT's Avatar
  • OFFLINE
  • Administrator
  • Posts: 4944
  • Thank you received: 84
  • Karma: 133
Jooa wrote:
I add the FOAM=1 and XYUV stuff in the INI file

What is FOAM and are there documents on this?

John
The administrator has disabled public write access.

Re:Limited velocity 28 Июл 2012 05:23 #22554

  • Jooa
  • Jooa's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 5
  • Karma: 0
:woohoo:
Thank you so so much! Works like a charm.

I saw a .ini file some time ago with [AXIS_ 'letter of the axis'] and thought that is more easier to read than numbers. So I changed numbers to letters. :blush: Didn't notice the velocity drop back then.

Thanks again for your work. Really appreciate.
Last Edit: 28 Июл 2012 05:25 by Jooa.
The administrator has disabled public write access.

Re:Limited velocity 28 Июл 2012 05:28 #22555

  • Jooa
  • Jooa's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 5
  • Karma: 0
Don't know about any documentation about that but I got it here.

In the comments.
Last Edit: 28 Июл 2012 05:36 by Jooa.
The administrator has disabled public write access.

Re:Limited velocity 31 Июл 2012 04:50 #22626

  • andypugh
  • andypugh's Avatar
  • OFFLINE
  • Moderator
  • Posts: 4103
  • Thank you received: 139
  • Karma: 129
ArcEye wrote:
The axes are notated in the .ini file as [AXIS_X] , [AXIS_Y] etc
I have not seen this before, haven't used stepconf for years, so maybe that is what is produced now.
I doubt it, as HAL is not the only consumer of INI data, and MOTION gets its info from the [AXIS_0] etc stanzas.
In fact, these are joint/actuator limits so should be numbered rather than lettered anyway.
(Unless the INI also contains [JOINT_0] Which I think it is the case in some variant branches.)
The administrator has disabled public write access.

Re:Limited velocity 24 Дек 2012 00:45 #27995

i don't know, i've been looking for these docs myself.

every time i think i've got it working i run into a joint error
The administrator has disabled public write access.
  • Page:
  • 1
  • 2
Moderators: Rick G
Time to create page: 1.398 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.