NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC Basic Configuration Need to connect pin problem

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

TOPIC: Need to connect pin problem

Re:Need to connect pin problem Edited 02 Июн 2012 15:16 #20619

  • cwebs
  • cwebs's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 123
  • Karma: 5
BigJohnT wrote:
I did notice something strange in show hal configuration when the signal name had a period in it. the name was displayed under machine instead of by itself... dunno if that has anything to do with the price of tea in China or not but that was the only thing I really changed.

John

I was wundering if you would pick up on that. Very good job, John
The administrator has disabled public write access.
Moderators: Rick G
Time to create page: 1.025 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.