NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum General General LinuxCNC Questions Spindle joint Following error

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1
  • 2

TOPIC: Spindle joint Following error

Re:Spindle joint Following error 05 Июл 2012 09:58 #21622

  • PCW
  • PCW's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1718
  • Thank you received: 92
  • Karma: 116
linuxcnc.org/docs/2.4/html/examples_spindle.html

Has some open loop examples
(you would have to change the hardware pin names)
The administrator has disabled public write access.

Re:Spindle joint Following error 05 Июл 2012 10:00 #21623

  • andypugh
  • andypugh's Avatar
  • OFFLINE
  • Moderator
  • Posts: 4249
  • Thank you received: 152
  • Karma: 130
SRT wrote:
I am retrofitting a Lathe with EMC. 30 Hp Reliance DC motor and spindle drive. My problem is following errors on the spindle joint......If I try to spin the axis by hand with EMC in the run state I get a following error

This is rather odd.
Which axis shows a following error?
Is it possible that the resolver numbers are mixed up? Can you check in machine->show hal config ("Watch" tab, the other tab isn't updated live) that moving the spindle changes the value of resolver.00, and that X and Z are on Resolver.01 and 02 ?

You are one of the very first users of the Resolver driver, so it is possible that there might be a mix-up inside the code.
The administrator has disabled public write access.

Re:Spindle joint Following error 05 Июл 2012 13:10 #21634

  • SRT
  • SRT's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 141
  • Thank you received: 1
  • Karma: 1
My spindle is fine........I was getting feed back on my x axis that was actually my joint error. I was hasty with the error.....because every time I touched the spindle I got the following error. I am goung to move the x axis away from the spindle on the resolver board. Thanks for the help today.
The administrator has disabled public write access.
  • Page:
  • 1
  • 2
Time to create page: 1.103 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.