NEWS
2.6 Live+Install image
There are no translations available.

Announcing a new Live+Install DVD image for installing LinuxCNC 2.6 on Debian Wheezy. Instructions here.

 
LinuxCNC 2.6.2 Released
There are no translations available.

Bug fix see the change log.

 
LinuxCNC 2.6.1 Released
There are no translations available.

Bug fix see the change log.

 
Home Forum Hardware & Machines Driver Boards Mesa 7I32 with 3x20/7I68

Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: Mesa 7I32 with 3x20/7I68

Mesa 7I32 with 3x20/7I68 02 Янв 2012 19:43 #16231

  • NicoP
  • NicoP's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
Hello,
I want to operate a stepper motor with a 7I32 card from MESA electronics. The bit patterns for turning the motor should come from a 3x20 anything I/O card on a 7I68 board.

Is there any "*.hal" file that meets the requirement?

If not, can anybody give me some advice, which hal modules should be used (PWM or stepgen)
and how they should be parameterized?

Can PNCconf create an appropriate configuration?


I installed the 10.04 Lucid Lynx Live CD and did an update of EMC to version 2.4.7.


Best regards
Nico
The administrator has disabled public write access.

Re:Mesa 7I32 with 3x20/7I68 02 Янв 2012 20:04 #16233

  • PCW
  • PCW's Avatar
  • NOW ONLINE
  • Moderator
  • Posts: 2629
  • Thank you received: 262
  • Karma: 138
The 7I32 it not really supported by EMC so I would not suggest using it for a EMC controlled application. I would instead suggest small gecko (G251)j or other step/dir drives
Its is supported by our SoftDC firmware for running small step motors in a closed loop configuration (this requires 30-50KHz control loop operation which is not practical with EMC)
The administrator has disabled public write access.
  • Page:
  • 1
Moderators: PCW, jmelson
Time to create page: 0.833 seconds
Powered by Kunena Forum
© 2014 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.