NEWS
LinuxCNC 2.5.4 Release
There are no translations available.

LinuxCNC 2.5.4 Update Released (changelog).
 
LinuxCNC 2.5.3 Release
There are no translations available.

LinuxCNC 2.5.3 Update Released (changelog).
 
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 

Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: halui incremental jog

halui incremental jog 01 Фев 2012 11:55 #17324

  • Rick G
  • Rick G's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1310
  • Thank you received: 44
  • Karma: 81
On 2.6 pre

When I enter

setp halui.jog.0.increment 0.1
setp halui.jog.0.increment-plus 1

In the test hal command area they are accepted and I can see the pins change.

I would expect one incremental jog of 0.1

However on Axis I see no results, am I missing something?

Rick G
The administrator has disabled public write access.

Re:halui incremental jog 01 Фев 2012 17:13 #17328

  • cmorley
  • cmorley's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1877
  • Thank you received: 101
  • Karma: 96
In Axis are you in manual mode?
The administrator has disabled public write access.

Re:halui incremental jog 02 Фев 2012 04:05 #17335

  • Rick G
  • Rick G's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1310
  • Thank you received: 44
  • Karma: 81
In Axis are you in manual mode?
Yes.
Just for fun I also tried MDI.

The other jog pins seem to work as expected in manual mode but not the above.

Rick G
The administrator has disabled public write access.

Re:halui incremental jog 02 Фев 2012 04:14 #17337

  • BigJohnT
  • BigJohnT's Avatar
  • NOW ONLINE
  • Administrator
  • Posts: 5804
  • Thank you received: 231
  • Karma: 155
Rick,

Did you set the increment-plus back to 0? Maybe it needs the on to off transition... just an early morning SWAG.

John
The administrator has disabled public write access.

Re:halui incremental jog 02 Фев 2012 04:33 #17339

  • Rick G
  • Rick G's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1310
  • Thank you received: 44
  • Karma: 81
Did you set the increment-plus back to 0? Maybe it needs the on to off transition
Morning John,

Yes, I believe it does need the transition. I toggled it back and forth, also tried a oneshot.

Rick G
The administrator has disabled public write access.

Re:halui incremental jog 06 Апр 2012 03:52 #19011

  • Rick G
  • Rick G's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1310
  • Thank you received: 44
  • Karma: 81
Turns out you need to set halui.jog-speed first to make this work.

Thanks to John for sorting this out.

Rick G
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 0.701 seconds
Powered by Kunena Forum
© 2014 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.