NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Using LinuxCNC G Code G64 P- Q- naive cam tolerance setting

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1

TOPIC: G64 P- Q- naive cam tolerance setting

G64 P- Q- naive cam tolerance setting 19 Апр 2012 04:07 #19371

Hope this isn't a daft question with an obvious answer, but I'm not sure what the Q setting units are in G64 P- Q- .
To quote the LinuxCNC User Guide:-

G64 P- Q- it turns on the "naive cam detector"; when there are a series of linear XYZ feed moves at
the same feed rate that are less than Q- away from being collinear, they are collapsed into a single
linear move.

'less than Q- away from being collinear' ? Would that be an angle or a linear distance?

:unsure:
The administrator has disabled public write access.

Re:G64 P- Q- naive cam tolerance setting 19 Апр 2012 05:47 #19373

  • andypugh
  • andypugh's Avatar
  • NOW ONLINE
  • Moderator
  • Posts: 4102
  • Thank you received: 139
  • Karma: 129
subtractive wrote:
'less than Q- away from being collinear' ? Would that be an angle or a linear distance?:

Linear AFAIK.
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 1.032 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.