NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC StepConf Wizard

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

Category Header

Forum Header

Topics in Category: StepConf Wizard

1 Replies emo
Two different step drivers?
Topic started 19 Янв 2013 23:47 by jaredts
453 Views
Last Post by cncbasher
20 Янв 2013 09:10
1 Replies emo
Axis runs 5 times farther
Topic started 18 Янв 2013 09:38 by belegnar
421 Views
Last Post by cncbasher
18 Янв 2013 10:44
6 Replies emo
different max speed for rapid and feed movement?
Topic started 11 Ноя 2012 13:19 by helig
856 Views
Last Post by helig
17 Ноя 2012 17:37
1 Replies emo
parallel port settings for Probotix meteor
Topic started 15 Ноя 2012 17:06 by rmattioda
465 Views
Last Post by BigJohnT
16 Ноя 2012 00:55
13 Replies emo
Driving a ULN2003 Darlington array IC
Topic started 24 Сен 2012 13:09 by liam2317
  • Page:
  • 1
  • 2
 7415 Views
Last Post by liam2317
30 Сен 2012 19:47
6 Replies emo
Setting for Gecko 210X
Topic started 02 Сен 2012 08:00 by Rick4004
4153 Views
Last Post by andypugh
04 Сен 2012 05:05
6 Replies emo
2 Parport with step config
Topic started 07 Авг 2012 01:46 by marcguenel
4242 Views
Last Post by BigJohnT
07 Авг 2012 09:06
3 Replies emo
How can I setup dual X motors in stepconf?
Topic started 28 Июл 2012 06:31 by CptanPanic
1767 Views
Last Post by Rick G
29 Июл 2012 02:47
51 Replies emo
Need Help
Topic started 21 Июн 2012 10:19 by ricky_a
14.4k Views
Last Post by ricky_a
14 Июл 2012 15:08
16 Replies emo
Syil stepper drivers
Topic started 03 Июл 2012 15:47 by tactustech
  • Page:
  • 1
  • 2
 6796 Views
Last Post by BigJohnT
10 Июл 2012 04:51
Time to create page: 1.384 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.