NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC StepConf Wizard Re:Configuring Spindle Feedback with Proximity Sensor

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
Forum Header
  • Page:
  • 1

TOPIC: Re:Configuring Spindle Feedback with Proximity Sensor

Re:Configuring Spindle Feedback with Proximity Sensor 28 Мар 2011 13:28 #8220

  • RotarySMP
  • RotarySMP's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 12
  • Karma: 0
Thanks for the quick replies Rus and John. It is getting late here, so I'll read the Basic Hal instruction before I turn in.

John that other thread link is this thread. Is there another good one out there? I searched for "spindle pulse" and the forum returns four pages of hits, but pages 2 through 4 come up empty when I click on them.
The administrator has disabled public write access.

Re:Configuring Spindle Feedback with Proximity Sensor 28 Мар 2011 13:33 #8221

  • BigJohnT
  • BigJohnT's Avatar
  • OFFLINE
  • Administrator
  • Posts: 5082
  • Thank you received: 102
  • Karma: 136
Unfortunately the search is a little broken. You can use a google site search like this

spindle threading site:www.linuxcnc.org

I didn't realize I was linking to this thread.

John
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 1.616 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.