NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC StepConf Wizard PWM not quite working

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
Forum Header

TOPIC: PWM not quite working

Re:PWM not quite working 27 Апр 2012 05:15 #19583

  • andypugh
  • andypugh's Avatar
  • OFFLINE
  • Moderator
  • Posts: 4244
  • Thank you received: 152
  • Karma: 130
jpka wrote:
I think to develop tiny atmel's based open source control device for ESCs, hope it will be also useful by someone else :-)

Thinking about it, somewhere I have a PWM duty cycle shifter for Arduino that I wrote for a problem at work. I will try to find it.
The administrator has disabled public write access.
Time to create page: 1.042 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.