anyone running a probotix rf breakout

ok so i got all the limits and home wired and i thought set in the wizard but every time i get a message' joint 0 on limit switch error" does anyone know where i messed up i have set the xyz to home and max limit pins 11 12 13 , with the limits in series both x then to the ground and board and so on . now when i manually trigger each limit the screen shows then come up but i can toggle the machine on in axis keeps giving mr the error .im pretty sure i have something wrong in the stepcon wizard

Have you tried inverting the signal?

Take a look here...

linuxcnc.org/docs/html/config_stepconf.h...sec:Axis-Travel-Home

Rick G

I'Il have to try that tonight. I read threw that whole section and missed the invert

Ok tryed to invert that didn't work

In the pin settings and it's wired like this www.probotix.com/diagrams/4-Axis_ProboStep_wiring_diagram.pdf

ok will do what am i looking for ? last time i opened that it was a long list

ok will do what am i looking for ? last time i opened that it was a long list

Try...

Machine
Show Hal configuration
pins
Axis

0 (for x axis)
or
1 (for y axis)
or
2 (for z axis) etc.

Select the tab "Watch"

look for
neg-lim-sw-in
pos-lim-sw-in

Now toggle your limit switch by hand and check to make sure that there is a response.

Rick G