NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Other Stuff Off Topic and Test Posts Thread lubricant

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1

TOPIC: Thread lubricant

Thread lubricant 28 Mag 2012 01:11 #20454

  • jpka
  • jpka's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 40
  • Thank you received: 2
  • Karma: 3
Hi!
I almost wear out native lubrication of my tiny machine. The machine was selled without any additional lubricant. It uses typical M10x1 pre-threaded rods. But when i try to apply typical general-purpose consistent grease like Lythol (lithium soap based), i notice that my thread become bare after few caret movements.
Native lubricant was "sticky" and does not remove after many caret movements.
So the question is, what is special sticky type of grease for thread shaft lubrication, and where to obtain it? I found nothing special on Ebay...
Thanks :-)
The administrator has disabled public write access.

Re:Thread lubricant 28 Mag 2012 01:25 #20455

  • ArcEye
  • ArcEye's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1418
  • Thank you received: 114
  • Karma: 130
Hi

Have you tried a non-fling synthetic open gear oil/grease?

I use a Molyslip spray grease (LQG I think) on my change gears on the manual lathe and it works fine.
Lasts a long time.

Might not be suited for a dusty workspace though, pretty sticky stuff.

regards
The administrator has disabled public write access.

Re:Thread lubricant 30 Mag 2012 00:23 #20503

  • jpka
  • jpka's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 40
  • Thank you received: 2
  • Karma: 3
ArcEye wrote:
Molyslip spray grease (LQG I think)
Thank you, i find something but not LQG exactly,
http://www.ebay.com/itm/Molyslip-OGL-Open-gear-lubericant-grease-450-gram-tub-/120598303270?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item1c14381226
But it looks too heavy for my tiny step motors... I also found other lube http://www.ebay.com/itm/Dow-Corning-1122-Chain-Open-Gear-Grease-Sealed-14oz-/200463637106?pt=Pneumatic_Hydraulic_Valves_Parts&hash=item2eac905a72 maybe this is suitable...
I also suddenly notice that bike chain also uses sticky grease and it looks and feels very close to native lubricant of my machine.
I will try both.
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 2.369 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.