NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum HAL HAL Components the problem of using "comp"

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1
  • 2

TOPIC: the problem of using "comp"

Re:the problem of using 14 Mag 2012 04:55 #20074

Thank you for replying!

I try to use "comp" in a IPC.Unbelievably,I succeed.

In the IPC,I install the linuxcnc with the same LiveCD that I used to intall linuxcnc into the VMware Workstation.I don't know why the result is different.

I think the reason is some bugs in my VM.I trust VM too much.

Best Regards!
The administrator has disabled public write access.
  • Page:
  • 1
  • 2
Time to create page: 0.775 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.