NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC StepConf Wizard 2 Parport with step config

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
Forum Header
  • Page:
  • 1
  • 2

TOPIC: 2 Parport with step config

Re:2 Parport with step config 07 Ago 2012 09:06 #22950

  • BigJohnT
  • BigJohnT's Avatar
  • OFFLINE
  • Administrator
  • Posts: 4940
  • Thank you received: 84
  • Karma: 133
I recommend starting by reading this page a couple of times to get up to speed with hal. Programming in hal is one line at a time so once you understand the net command you have 75% under your belt... the rest is just picking the right pins to use.

John
Last Edit: 07 Ago 2012 09:18 by BigJohnT.
The administrator has disabled public write access.
  • Page:
  • 1
  • 2
Time to create page: 0.808 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.