NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC StepConf Wizard emc2 don't start ....

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
Forum Header
  • Page:
  • 1
  • 2

TOPIC: emc2 don't start ....

Re:emc2 don't start .... 12 Ago 2011 03:41 #12451

  • Rick G
  • Rick G's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1070
  • Thank you received: 15
  • Karma: 80
Have you looked here...
wiki.linuxcnc.org/emcinfo.pl?TroubleShooting
Were you able to run a latency test?

Rick G
The administrator has disabled public write access.

Re:emc2 don't start .... 12 Ago 2011 04:41 #12454

  • BigJohnT
  • BigJohnT's Avatar
  • NOW ONLINE
  • Administrator
  • Posts: 4955
  • Thank you received: 87
  • Karma: 134
Which config are you trying to run?

John
The administrator has disabled public write access.

Re:emc2 don't start .... 12 Ago 2011 05:47 #12457

  • thor1966
  • thor1966's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 5
  • Karma: 0
resolved. Pin wrong for digitizing error during config
The administrator has disabled public write access.

Re:emc2 don't start .... 01 Lug 2012 09:21 #21472

  • jy76
  • jy76's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 14
  • Karma: 0
quiet splash lapic in grub the wiki tells how to do this
The administrator has disabled public write access.
  • Page:
  • 1
  • 2
Time to create page: 1.120 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.