NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Getting LinuxCNC Installing LinuxCNC EMC2 on Puppy linux.

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

TOPIC: EMC2 on Puppy linux.

Re:Curious for puppy too 07 Nov 2011 23:31 #14667

  • ArcEye
  • ArcEye's Avatar
  • NOW ONLINE
  • Moderator
  • Posts: 1335
  • Thank you received: 102
  • Karma: 129
I'll try to have another play with this later, probably try for a Debian small installation image so that it will run an unpatched clean kernel, and work from there.

Work piling up at present.

regards
The administrator has disabled public write access.
Time to create page: 1.572 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.