NEWS
LinuxCNC 2.5.4 Release
There are no translations available.

LinuxCNC 2.5.4 Update Released (changelog).
 
LinuxCNC 2.5.3 Release
There are no translations available.

LinuxCNC 2.5.3 Update Released (changelog).
 
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
Home Forum Configuring LinuxCNC GladeVCP any examples of adding pendant or handwheel

Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: any examples of adding pendant or handwheel

any examples of adding pendant or handwheel 22 Nov 2011 10:30 #15025

  • cncbasher
  • cncbasher's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1062
  • Thank you received: 94
  • Karma: 60
Hi ,
i know glade is new and in it's infant stages , but has anyone implemented on screen menu / display for a pendant or using Handwheels

reason i ask is i am looking for guidance on 2 related aspects , using a onscreen display of a pendant from within glade
and interfacing 2 encoder handwheels for x & z axis , with the facility of an onscreen toggle button to switch between standard mode and velocity mode of the handwheels
this expanding it's use to a manual lathe ( or mill for that matter ) sort of fly by wire ! .

and anyone implemented this ?
or any examples , while i brush up on gladevcp ?

any thoughts welcome too

i was also thinking does Gladevcp have the ability to hide a panel and pop up on a keypress perhaps

Dave
The administrator has disabled public write access.
  • Page:
  • 1
Moderators: mhaberler
Time to create page: 0.889 seconds
Powered by Kunena Forum
© 2014 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.