NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum General General LinuxCNC Questions

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

Topics in Category: General LinuxCNC Questions

12 Replies emo
Moving X and Y tangent to Z
Topic started 14 Mai 2012 10:24 by mmt
  • Page:
  • 1
  • 2
 5124 Views
Last Post by andypugh
22 Mai 2012 08:28
30 Replies emo
LinuxCNC for low level stepper motor control?
Topic started 24 Apr 2012 05:19 by Smecky
11.9k Views
Last Post by wizard69
21 Mai 2012 07:05
6 Replies emo
anybody have the source code of the PID component?
Topic started 09 Mai 2012 17:42 by awesomepanda
3560 Views
Last Post by andypugh
14 Mai 2012 06:37
13 Replies emo
No step pulse output from parallel port
Topic started 03 Apr 2012 06:34 by skarnsungen
  • Page:
  • 1
  • 2
 6758 Views
Last Post by pfred1
09 Mai 2012 16:38
13 Replies emo
basic 3-phase xfmr power supply questions. re:7i29
Topic started 01 Mai 2012 03:38 by _jC
  • Page:
  • 1
  • 2
 5899 Views
Last Post by andypugh
07 Mai 2012 14:47
21 Replies emo
Encoders vs. Tachometers ???
Topic started 04 Mai 2012 08:11 by _jC
8794 Views
Last Post by _jC
06 Mai 2012 23:28
16 Replies emo
lathe g76 feed jerky
Topic started 09 Apr 2012 19:38 by genec
  • Page:
  • 1
  • 2
 6104 Views
Last Post by andypugh
26 Apr 2012 06:30
5 Replies emo
Will LinuxCNC Run On PC-BSD Hubble 8.0
Topic started 24 Mär 2012 22:15 by neu
1878 Views
Last Post by Mooselake
21 Apr 2012 15:05
14 Replies emo
EMC2 on a Mac
Topic started 16 Apr 2012 03:23 by ThLDQ
  • Page:
  • 1
  • 2
 6547 Views
Last Post by wizard69
21 Apr 2012 11:00
10 Replies emo
Using image-to-gcode - tool diameter problem
Topic started 20 Apr 2012 08:07 by grey1beard
  • Page:
  • 1
  • 2
 3787 Views
Last Post by grey1beard
21 Apr 2012 07:23
Time to create page: 1.539 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.