NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Other Stuff OT Posts Double S velocity profile and max speed

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

TOPIC: Double S velocity profile and max speed

Re:Double S velocity profile and max speed 25 Juil 2012 16:30 #22467

  • VNR
  • VNR's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 59
  • Thank you received: 2
  • Karma: 5
Where is the trajectory planner in the source code?
May be it could be a good starting point: wiki.linuxcnc.org/cgi-bin/wiki.pl?Simple_Tp_Notes
The administrator has disabled public write access.

Re:Double S velocity profile and max speed 28 Juil 2012 18:30 #22571

  • diegoroman17
  • diegoroman17's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 126
  • Thank you received: 2
  • Karma: 0
It is very interesting. I study this doc a deep. I plan begin with this study case the next month.
The administrator has disabled public write access.
Time to create page: 1.398 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.