NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Hardware Driver Boards I/O Interface Board Recommendation For Lathe

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

TOPIC: I/O Interface Board Recommendation For Lathe

Re:I/O Interface Board Recommendation For Lathe 01 Jan 2012 15:19 #16195

  • andypugh
  • andypugh's Avatar
  • OFFLINE
  • Moderator
  • Posts: 4126
  • Thank you received: 141
  • Karma: 129
BruceLayne wrote:
The spindle seems to turn at the proper speed and hold speed under a light load, but I can stall it by hand.
I wouldn't really expect to be able to stall the spindle by hand (well, I wouldn't try, anyway) at 30Hz and the gear you appear to have selected there.
I think you might need to adjust the current limits, ramp speed and v/f ratio for the inverter.
The administrator has disabled public write access.
Moderators: PCW, jmelson
Time to create page: 1.057 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.