NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Using LinuxCNC AXIS Starting AXIS with another ".ngc" File

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1

TOPIC: Starting AXIS with another ".ngc" File

Starting AXIS with another ".ngc" File 29 Jan 2010 04:43 #1686

  • inet
  • inet's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 4
  • Karma: 0
Hi,

Is it possible to start AXIS with a .ngc file other than "axis.ngc"?


Thanks,

David
Last Edit: 29 Jan 2010 04:44 by inet.
The administrator has disabled public write access.

Re:Starting AXIS with another ".ngc" File 29 Jan 2010 05:41 #1687

  • acemi
  • acemi's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 55
  • Karma: 6
http://www.linuxcnc.org/docs/devel/html/config_ini_config.html#sub:%5BDISPLAY%5D-section

In DISPLAY section in ini file:
OPEN_FILE = /full/path/to/file.ngc
The administrator has disabled public write access.

Re:Starting AXIS with another ".ngc" File 29 Jan 2010 05:48 #1688

  • inet
  • inet's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 4
  • Karma: 0
Thanks, it worked perfectly!
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 0.910 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.