NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Using LinuxCNC AXIS 4th Axis home

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1

TOPIC: 4th Axis home

4th Axis home 23 Nov 2009 14:12 #1178

  • Scooter
  • Scooter's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
Hi all, I am using incremental angular steps on the 4th axis (rotation) . When the machining is finished the 4th axis is several revolution pasts "home" but is in the same actual position as home. Is there a command to reset home for the rotary axis without actually rotating it?

Thanks for any help.
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 1.083 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.