×
Forum Header
anyone running a probotix rf breakout
10 Dec 2011 15:11 #15528
by tjfisher
anyone running a probotix rf breakout was created by tjfisher
ok so i got all the limits and home wired and i thought set in the wizard but every time i get a message' joint 0 on limit switch error" does anyone know where i messed up i have set the xyz to home and max limit pins 11 12 13 , with the limits in series both x then to the ground and board and so on . now when i manually trigger each limit the screen shows then come up but i can toggle the machine on in axis keeps giving mr the error .im pretty sure i have something wrong in the stepcon wizard
Please Log in or Create an account to join the conversation.
10 Dec 2011 19:21 #15533
by Rick G
Replied by Rick G on topic Re:anyone running a probotix rf breakout
Have you tried inverting the signal?
Take a look here...
linuxcnc.org/docs/html/config_stepconf.h...sec:Axis-Travel-Home
Rick G
Take a look here...
linuxcnc.org/docs/html/config_stepconf.h...sec:Axis-Travel-Home
Rick G
Please Log in or Create an account to join the conversation.
10 Dec 2011 20:18 #15534
by tjfisher
Replied by tjfisher on topic Re:anyone running a probotix rf breakout
I'Il have to try that tonight. I read threw that whole section and missed the invert
Please Log in or Create an account to join the conversation.
11 Dec 2011 01:14 #15540
by tjfisher
Replied by tjfisher on topic Re:anyone running a probotix rf breakout
Ok tryed to invert that didn't work
Please Log in or Create an account to join the conversation.
11 Dec 2011 01:37 #15542
by andypugh
Replied by andypugh on topic Re:anyone running a probotix rf breakout
tjfisher wrote:
It has to. The home switch can't be both on and off all the time..
What did you invert, and where?
Ok tryed to invert that didn't work
It has to. The home switch can't be both on and off all the time..
What did you invert, and where?
Please Log in or Create an account to join the conversation.
11 Dec 2011 13:06 #15547
by tjfisher
Replied by tjfisher on topic Re:anyone running a probotix rf breakout
In the pin settings and it's wired like this www.probotix.com/diagrams/4-Axis_ProboStep_wiring_diagram.pdf
Please Log in or Create an account to join the conversation.
Time to create page: 1.092 seconds