Gcode for LinuxCNC and BeBoPr

More
15 Jul 2014 14:19 #48798 by Etiens
Hi,

I'm using the BeBoPr++ cape and LinuxCNC to run a 3D printer.
I'm using Slic3r but I think is not fully compatible.
Do do you know the Gcode command to set J2-J3-J4 PWM output for heaters?
Thanks

Please Log in or Create an account to join the conversation.

More
15 Jul 2014 22:13 #48809 by ArcEye
Hi

I should join the MachineKit google group and ask on there. (MachineKit is a fork of the Linuxcnc project)

groups.google.com/forum/#!forum/machinekit

A lot of them use BBB for Reprap and there is a lot of knowledge in that area on the mailing list

regards

Please Log in or Create an account to join the conversation.

Time to create page: 0.069 seconds
Powered by Kunena Forum