instalation tb6560

i install all linuxcnc on new computer its ok on ubuntu 8.04

al the 3 axis move well on stepconf x y z

when i laught linuccnc nothing move the latency test is 16500ns

i put for the parrallel all value that i find on the forun but whitout result



what happen ???

thanks

see wiki.linuxcnc.org/uploads/TB6560.tar.gz

the connection worth noting is the amplifier enable needs to be set as a digital pin

post your hal and ini files as attachments ,

i join 2 files ini and hal with that config the 3 axxis turn well when i test them on stepconf

but not on linuxcnc 2.5.1 on ubunti 8.04

forgive me for more information ...

you seem to have centre of each axis as 0 is this a delta or 3d printer ?
if it is a mill, it's usual to have 0 at left side of travel and at top of z

also you seem to have a different version of a TB6560 that i am aware of do you have a pdf of the manual
and can you see any version number .

also change

stepspace to 0 in your hal file
dirhold to 63100

you also have adir and and astep is this a spindle stepper ?


also see the wiki for the TB6560 V5
wiki.linuxcnc.org/uploads/tb6560_v5.gz

I'm sure you have the pinouts incorrect for your board , more importantly the amplifier enable pin
but due to the number of differences these particular boards have and indeed different pinouts to even the manual , they can become difficult to figure out

the card is a tb6560 4 axis the address for pdf files is:

docs.google.com/viewer?a=v&q=cache:K7YT-...4h5ItT3GNhOLvJN_4mSQ

or on google tb6560 4axes blue card whit fan

i have nothing more , on the card not nomber or n° serie

perhaps i see that kernel is mini 35 000 hrz on pdf doc

i modify to 0 and 63100 its the same thing nothing on mill but ok on stepcomf

i modify the travel

and i join new ini and hal






regards

i find the factory of this card : www.hyu68.com/HY-TA4DV-M.htm

but i can t propriety of her

you have the 4 axis version

i make the following pins

x axis
step pin 16
dir pin 1
enable pin 4

y axis
step pin 14
dir pin 7
enable pin 17

z axis
step pin 3
dir pin 6
enable 5

a axis
step pin 9
dir pin 8
enable 5


estop pin 13 ( if used )

limits ( if used )
x axis pin 10
y axis pin 11
z axis pin 12

spindle relay pin 2 ( output )

i have not problen whith the pin all is ok the motor run well when i test it in stepconf for x an y an z
i see in you reponse you inverse step an dir and you note 2 times pin 7 it not matter i rectify it

I contrôle all pin of thé parallèle port. All Is ok

With stepcomf all axis x y z well . I change thé speed And the vélocity to adapt With my motors And my mill.

When i test in stepconf i ear à little click in bordercard for every axis.

When i laught linuxcnc i click on estop ,clic on the "x". And after ">". At this moment i ear thé same click than Before With stepconf ,in thé screen i see all gcode move but not on my mill.

??????

'

please try the attached hal file