NEWS
LinuxCNC 2.5.2 Release
LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC PnCConf Wizard 7i77 Question

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1

TOPIC: 7i77 Question

7i77 Question 04 Aug 2012 20:28 #22836

  • Todd Zuercher
  • Todd Zuercher's Avatar
  • OFFLINE
  • Gold Boarder
  • Posts: 262
  • Thank you received: 21
  • Karma: 8
I am just starting to configure my first 7i77 setup. I have a simple question.
While I was trying to use PNCConf I did not notice where the drive enable switches (the 4 and 5th that go with the analog outs) are configured. Where and how are those assigned, or are they automatically set up when the pwms for the analog outs are configured?
The administrator has disabled public write access.

Re:7i77 Question 04 Aug 2012 20:49 #22838

  • cmorley
  • cmorley's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1489
  • Thank you received: 40
  • Karma: 89
there are only two enables.
one for the 0-4 analogs
and one for the 5th

the 5th is set up that way so you could enable a spindle separately.

if you look in the x axis section :
# enable _all_ sserial pwmgens
net x-enable hm2_5i25.0.7i77.0.1.analogena

if you select an analog spindle use analog 5
The administrator has disabled public write access.
  • Page:
  • 1
Moderators: cmorley
Time to create page: 1.197 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.