NEWS
LinuxCNC 2.5.2 Release
LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC pyVCP u32 image

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

TOPIC: u32 image

Re:u32 image 11 Jul 2011 13:52 #11432

  • piasdom
  • piasdom's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 537
  • Karma: 2
i'm sorry, but i'm not trying to get you to do any of this for me and thanks
for giving me this info. but i think i'm not reading the same docs :)
as i never seen any of these before. i don't mind reading thru these
or any info i get from this forum. and what i understood from the doc
i did read, what i had should have worked as i use the example
in the doc.(www.linuxcnc.org/docview/html/hal_pyvcp.html#r1_6_6).
in the example, it only shows what i used. but i'll continue reading.
i appreciate any help !

Thank andy !
Last Edit: 11 Jul 2011 14:11 by piasdom.
The administrator has disabled public write access.

Re:u32 image 11 Jul 2011 14:22 #11434

  • piasdom
  • piasdom's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 537
  • Karma: 2
this is a better doc, was i suppose to be reading this one all this time ?:)

www.linuxcnc.org/docview/2.5/html/hal/ba..._a_id_sec_hal_data_a
Last Edit: 12 Jul 2011 03:18 by piasdom.
The administrator has disabled public write access.
Time to create page: 0.857 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.