Challenge ODROID-U3 - LinuxCNC

Start
Prev
1
Next
End

ADBensi
Offline
Junior Member

18 Apr 2014 20:29 #46080 by ADBensi

Challenge ODROID-U3 - LinuxCNC was created by ADBensi

I saw the LinuxCNC from this topic
linuxcnc.org/index.php/english/forum/18-...n-raspberry-pi/46028

Among some ideas came to ODROID LinuxCNC,
To discuss it I thought it best to leave the topic dedicated to Raspberry and go for this.

What do you think? I am waiting for my ODROID-U3

Please Log in or Create an account to join the conversation.

andypugh
Offline
Moderator

21 Apr 2014 06:06 #46149 by andypugh

Replied by andypugh on topic Challenge ODROID-U3 - LinuxCNC

ADBensi wrote:
What do you think? I am waiting for my ODROID-U3

it should be possible with Machinekit, but not easily with LinuxCNC (No ARM support in LinuxCNC, and only support for RTAI).

There are folk interested in running Xenomain on Odroid, and Machinekit can run on ARM and Xenomai. At the moment Machinekit is LinuxCNC+, bit I expect it will diverge eventually.

Please Log in or Create an account to join the conversation.

ADBensi
Offline
Junior Member

21 Apr 2014 20:43 #46173 by ADBensi

Replied by ADBensi on topic Challenge ODROID-U3 - LinuxCNC

Hello!

Machinekit is an installation image to BBB using EMC2 ?

The hardest part would be to develop a driver. I think it would be appropriate to use as the base project PICnC Jr (PIC32 over DMA). We consider SPI Custom drive in the 6 GPIOs exposed on the Odroid U3.

I'll test PREEMPT_RT and Xenomai in ODROID and post the results here, and if something does not work in the board.

Best Regards,

Please Log in or Create an account to join the conversation.

andypugh
Offline
Moderator

22 Apr 2014 00:37 #46186 by andypugh

Replied by andypugh on topic Challenge ODROID-U3 - LinuxCNC

ADBensi wrote:
Machinekit is an installation image to BBB using EMC2 ?,

Not exactly.

www.machinekit.io

Please Log in or Create an account to join the conversation.

ADBensi
Offline
Junior Member

22 Apr 2014 01:49 #46192 by ADBensi

Replied by ADBensi on topic Challenge ODROID-U3 - LinuxCNC

is my impression or K9 driver for BBB access GPIO from Linux user space (/sys/class/gpio/)?
github.com/machinekit/machinekit/blob/ma...figs/setup.K9-DTO.sh

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.075 seconds