NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC Basic Configuration

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

Topics in Category: Basic Configuration

0 Replies emo
Sample Configurations
Topic started 23 Фев 2013 12:14 by BigJohnT
774 Views
Last Post by BigJohnT
23 Фев 2013 12:14
 
1 Replies emo
View or indicate encoder index pulse
Topic started 18 Июн 2013 21:31 by spangledboy
34 Views
Last Post by PCW
18 Июн 2013 23:23
2 Replies emo
Spindle Step/Dir
Topic started 15 Июн 2013 13:30 by jbradshaw
88 Views
Last Post by jbradshaw
15 Июн 2013 17:45
2 Replies emo
Old Installation - 6.06 and 2.1.0
Topic started 07 Июн 2013 08:16 by electrosteam
64 Views
Last Post by electrosteam
07 Июн 2013 11:19
43 Replies emo
Maximum Velocity Setting Locations?
Topic started 10 Май 2013 16:34 by Paul
673 Views
Last Post by bjames28
05 Июн 2013 03:27
16 Replies emo
GS-2 Spindle Configuration
Topic started 31 Май 2013 21:03 by ddmotim
  • Page:
  • 1
  • 2
 171 Views
Last Post by ddmotim
04 Июн 2013 20:44
8 Replies emo
Mesa 5i20 + step/dir servos, what daughter card?
Topic started 03 Июн 2013 16:21 by robonix10
97 Views
Last Post by robonix10
04 Июн 2013 16:04
6 Replies emo
Closed Loop Stepper System?
Topic started 03 Июн 2013 02:18 by Zahnrad Kopf
92 Views
Last Post by Zahnrad Kopf
03 Июн 2013 13:08
19 Replies emo
Mesa / HostMot
Topic started 22 Май 2013 11:11 by eslavko
  • Page:
  • 1
  • 2
 201 Views
Last Post by andypugh
03 Июн 2013 09:06
3 Replies emo
Setting up some kind of RAMP on the steppers?
Topic started 01 Июн 2013 16:31 by giggler999
95 Views
Last Post by Todd Zuercher
02 Июн 2013 18:12
Moderators: Rick G
Time to create page: 2.341 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.