NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Using LinuxCNC G Code Problem with G33.1 and Ver 2.6?

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1

TOPIC: Problem with G33.1 and Ver 2.6?

Problem with G33.1 and Ver 2.6? 26 Май 2012 17:19 #20434

A few days ago I installed version 2.6 it seems to work except when I attempt to use a G33.1
like G33.1 Z-0.750 K0.05 the spindle makes about one rev then the Z axis stops.

I have used HAL Scope to look at the spindle encoder index pulse it appears to be working
fine and G33.1 worked with Ver 2.3

Any idea as to the problem?????
The administrator has disabled public write access.

Re:Problem with G33.1 and Ver 2.6? 28 Май 2012 04:45 #20458

  • andypugh
  • andypugh's Avatar
  • NOW ONLINE
  • Moderator
  • Posts: 4135
  • Thank you received: 141
  • Karma: 129
garymcrobertpdx wrote:
A few days ago I installed version 2.6 it seems to work except when I attempt to use a G33.1
like G33.1 Z-0.750 K0.05 the spindle makes about one rev then the Z axis stops.
That sounds like it might be expensive.

The sim-lathe sample config has a spindle encoder. Can you see if that shows the same problem? (being a sim it won't break any real-world taps)
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 0.782 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.