×
Forum Header
stepconf woes..
22 May 2011 03:05 #9982
by submicro
stepconf woes.. was created by submicro
Hello
Does anyone running a keling 3 axis kit with kl4030's and c10 breakout board wanna share they're .hal file so I can compare. I'm still unable to get my motors stepping. when in EMC using show hal configuration it shows my x,y,z pins as in not out??? I've tested my parallel port and i have +5v on pins 8 thru 12 but not on the rest.
Does anyone running a keling 3 axis kit with kl4030's and c10 breakout board wanna share they're .hal file so I can compare. I'm still unable to get my motors stepping. when in EMC using show hal configuration it shows my x,y,z pins as in not out??? I've tested my parallel port and i have +5v on pins 8 thru 12 but not on the rest.
Please Log in or Create an account to join the conversation.
22 May 2011 07:43 #9983
by cncbasher
Replied by cncbasher on topic Re:stepconf woes..
pins voltages are not reliable as an indication , as some pins are bidirectional and therfore give the wrong voltages , the 5volts you are seeing are because the pins are classed as Inputs
can you post your hal file please , also which version of emc and ubunto are you using
Dave
can you post your hal file please , also which version of emc and ubunto are you using
Dave
Please Log in or Create an account to join the conversation.
22 May 2011 10:53 #9984
by BigJohnT
Replied by BigJohnT on topic Re:stepconf woes..
Please read this page to understand the ins and outs of pins.
www.linuxcnc.org/docview/html/hal_basic_hal.html
John
www.linuxcnc.org/docview/html/hal_basic_hal.html
John
Please Log in or Create an account to join the conversation.
22 May 2011 21:14 - 22 May 2011 21:16 #9990
by submicro
Replied by submicro on topic Re:stepconf woes..
i'm not sure how to post a file but here goes....
i'm using EMC2 2.4.6
linux kernel 2.6.32-122rtai
i'm using EMC2 2.4.6
linux kernel 2.6.32-122rtai
Last edit: 22 May 2011 21:16 by submicro.
Please Log in or Create an account to join the conversation.
23 May 2011 07:27 #9991
by cncbasher
Replied by cncbasher on topic Re:stepconf woes..
i'd guess your problem is in the enable , if your using the enable lines to your stepper drivers , remove the wire and you should find it will work
have you connected the enable input ? or using the charge pump
have you connected the enable input ? or using the charge pump
Please Log in or Create an account to join the conversation.
23 May 2011 14:22 #9994
by submicro
Replied by submicro on topic Re:stepconf woes..
I'm not using the enable lines, and I have the enable on the c10 jumpered. I'm not using a charge pump, I'm not sure what it is.
Please Log in or Create an account to join the conversation.
Time to create page: 0.104 seconds