NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC Advanced Configuration Acceleration of U-Axis asynchronous to XYZ

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

TOPIC: Acceleration of U-Axis asynchronous to XYZ

Re:Acceleration of U-Axis asynchronous to XYZ 25 Июн 2012 12:42 #21320

  • PCW
  • PCW's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1714
  • Thank you received: 92
  • Karma: 116
I am wondering if there is any scope for using adaptive feed based on a goop-pressure sensor.

Or it that's too hard sensor wise, model the extruder and use that for the adaptive feed rate control
The administrator has disabled public write access.

Re:Acceleration of U-Axis asynchronous to XYZ 25 Июн 2012 13:18 #21321

Hi Andy,
I have done this plot:


Tomorrow I will try to write an own comp for my extruder.

Is there perhaps a tutorial or something else here in the forum?
I think, I have to install additional environment packages (e.g. gcc) - or is this already shipped with the LiveCD?

Best Regards,

Andy
The administrator has disabled public write access.

Re:Acceleration of U-Axis asynchronous to XYZ 25 Июн 2012 13:25 #21323

  • BigJohnT
  • BigJohnT's Avatar
  • OFFLINE
  • Administrator
  • Posts: 5075
  • Thank you received: 101
  • Karma: 135
Well you might start with the comp manual...

John
The administrator has disabled public write access.
Time to create page: 1.089 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.