NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Using LinuxCNC AXIS Another tab for WebCam

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

TOPIC: Another tab for WebCam

Re:Another tab for WebCam 26 Apr 2012 04:04 #19547

  • strykerg
  • strykerg's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 49
  • Karma: 1
crap looks i fked up my linuxcnc installation :(

when i tried doing sudo apt-get install camunits-plugins-emc it said something like dependency missing "emc-sim" or emc-fake something like that

i installed that, then installed camunits plugins and now linuxcnc is gone :(
The administrator has disabled public write access.

Re:Another tab for WebCam 26 Apr 2012 04:27 #19549

  • psha
  • psha's Avatar
  • OFFLINE
  • Moderator
  • Posts: 107
  • Karma: 22
Heh, i bet you've installed emc-sim? :)
emc-fake-sim is just a workaround ot provide one package for bot sim and rt installations
Just install emc2 back and you'll be fine
The administrator has disabled public write access.

Re:Another tab for WebCam 26 Apr 2012 04:43 #19550

  • psha
  • psha's Avatar
  • OFFLINE
  • Moderator
  • Posts: 107
  • Karma: 22
Hm, my fault. emc2 package name changed to linuxcnc so dependencies are a bit broken
The administrator has disabled public write access.

Re:Another tab for WebCam 26 Apr 2012 04:51 #19551

  • strykerg
  • strykerg's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 49
  • Karma: 1
nevermind I wanted to do a fresh install anyway since i have 2gig ram i could remove the swap partition...

now i hope i can install the camera apps again! :)

so after i re-install everything, what do i need to do to get the dro on my camera embedded window?
The administrator has disabled public write access.

Re:Another tab for WebCam 26 Apr 2012 05:31 #19552

  • psha
  • psha's Avatar
  • OFFLINE
  • Moderator
  • Posts: 107
  • Karma: 22
You need to wait until i provide new transition (emc2-fake-sim) package
Probably it will be in the repo this evening (i'm on GMT+4 timezone)
The administrator has disabled public write access.

Re:Another tab for WebCam 26 Apr 2012 07:54 #19556

  • strykerg
  • strykerg's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 49
  • Karma: 1
finally managed to log in again to the forum :)

ok psha thanks for now - my cnc is up and running again just as it was. pretty easy to set it up again when you learned the hard way :)
The administrator has disabled public write access.
Time to create page: 1.439 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.