NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC Basic Configuration V90 cnc cant use the swits

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1

TOPIC: V90 cnc cant use the swits

V90 cnc cant use the swits 06 Jun 2012 12:19 #20687

  • Frederik
  • Frederik's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 19
  • Karma: 0
I have a V90 from Probotix which run with emc2, which run as it should. I have just fitted swits on x and y Jay Adams, but nothing happens any time. Cables are checked NC, and I have set x and y to the home, it is just and is ticking slowly but ignore swits. If I go in hal test shifts the nor. I have downloaded V90 ini from probotix, but nothing helps. Is there anyone who can help me. ..?
The administrator has disabled public write access.
  • Page:
  • 1
Moderators: Rick G
Time to create page: 0.875 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.