NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC GUI's Help in GUI

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1

TOPIC: Help in GUI

Help in GUI 08 Sep 2010 18:59 #4065

  • aike
  • aike's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 147
  • Karma: 3
Hi!
I want to connect emc2 to external controller. This controller wiil have only 4-5 buttoms (start, stop, run, left, right).
The computer will be switched on without display. How can I start emc without GUI? Is it possible?
The conection between emc2 and external controller will be via Mesa5i20 in/out pins.
May be amybody did it so? Can you help me in advice?
The administrator has disabled public write access.

Re:Help in GUI 09 Sep 2010 02:54 #4072

  • andypugh
  • andypugh's Avatar
  • OFFLINE
  • Moderator
  • Posts: 4245
  • Thank you received: 152
  • Karma: 130
If the display is not turned on or fitted, does it matter if there is a GUI or not?
You should be able to wire all the necessary GUI buttons to physical buttons if you load halui.
linuxcnc.org/docs/html/gui_halui.html
You might find that if you delete the line in the INI file that refers to AXIS that no GUI is loaded, I am not entirely sure.
linuxcnc.org/docs/2.2/html/config_ini_co...5BDISPLAY%5D-Section
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 1.086 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.