Traub Bosch cc100 retrofit

More
06 Jun 2015 18:22 #59511 by aventtini





just fit the drives in place now i have a small problem . Cncbasher hook the wires for the encoders and some of the limits but i dont know if all of them . I will try to rewire the machine on the mesa and see exacly what is instaled . Also the M19 is the POS on the spindle module and it was working then i got the bosch plc out

Please Log in or Create an account to join the conversation.

More
06 Jun 2015 22:38 #59530 by aventtini
I just rewire some of the old changer wires but i was thinking that i will use like a normal axis the all tool changer . That mens we have power on the tool changer all the time , I was thinking my drives are to small for this . I will connect them in the safety loop . Based on the encoder i know exsclly the tool position after homing thats the good part .

Please Log in or Create an account to join the conversation.

More
09 Jun 2015 18:13 - 10 Jun 2015 01:01 #59650 by aventtini
I solve the wiring now we go to the unknown part the linuxcnc setup
Last edit: 10 Jun 2015 01:01 by aventtini.

Please Log in or Create an account to join the conversation.

More
10 Jun 2015 15:52 #59667 by aventtini
i have a quick question if i dont have torque on stand still it can be a problem . The encoder will compensate when it will start agen the next tool change ? Or it will give a error on the FF vautes ?

Please Log in or Create an account to join the conversation.

Time to create page: 0.093 seconds
Powered by Kunena Forum