NEWS
LinuxCNC 2.5.2 Release
LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC Basic Configuration

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?

Topics in Category: Basic Configuration

0 Replies emo
Sample Configurations
Topic started 23 Feb 2013 12:14 by BigJohnT
653 Views
Last Post by BigJohnT
23 Feb 2013 12:14
 
1 Replies emo
Machine Home vs Part Home
Topic started 21 May 2013 23:47 by mud99
10 Views
Last Post by cmorley
22 May 2013 00:31
27 Replies emo
Maximum Velocity Setting Locations?
Topic started 10 May 2013 16:34 by Paul
295 Views
Last Post by Paul
21 May 2013 03:00
4 Replies emo
Carving half the size of G code created in PyCam
Topic started 18 May 2013 23:15 by Nenad
77 Views
Last Post by andypugh
19 May 2013 13:01
0 Replies emo
THC Up Down Simulator
Topic started 19 May 2013 12:03 by BigJohnT
64 Views
Last Post by BigJohnT
19 May 2013 12:03
4 Replies emo
Need to decode what this means.... :(
Topic started 18 May 2013 16:02 by dovidu
81 Views
Last Post by ArcEye
19 May 2013 09:50
5 Replies emo
Spindle true RPM..... HELP PLEASE!!!
Topic started 18 May 2013 15:14 by dovidu
77 Views
Last Post by ArcEye
19 May 2013 09:39
9 Replies emo
port parallel
Topic started 13 May 2013 19:16 by charrier
153 Views
Last Post by ArcEye
17 May 2013 16:46
6 Replies emo
home switch issues
Topic started 09 May 2013 01:43 by rotccapt
130 Views
Last Post by willburrrr2003
17 May 2013 16:31
7 Replies emo
cncgeeker config?
Topic started 14 May 2013 05:23 by ShreddinPB
109 Views
Last Post by ShreddinPB
16 May 2013 16:23
Moderators: Rick G
Time to create page: 1.332 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.