stepconf woes..

Hello

Does anyone running a keling 3 axis kit with kl4030's and c10 breakout board wanna share they're .hal file so I can compare. I'm still unable to get my motors stepping. when in EMC using show hal configuration it shows my x,y,z pins as in not out??? I've tested my parallel port and i have +5v on pins 8 thru 12 but not on the rest.

pins voltages are not reliable as an indication , as some pins are bidirectional and therfore give the wrong voltages , the 5volts you are seeing are because the pins are classed as Inputs

can you post your hal file please , also which version of emc and ubunto are you using

Dave

i'm not sure how to post a file but here goes....


i'm using EMC2 2.4.6
linux kernel 2.6.32-122rtai

i'd guess your problem is in the enable , if your using the enable lines to your stepper drivers , remove the wire and you should find it will work
have you connected the enable input ? or using the charge pump

I'm not using the enable lines, and I have the enable on the c10 jumpered. I'm not using a charge pump, I'm not sure what it is.