NEWS
LinuxCNC 2.5.2 Release
LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC StepConf Wizard Need Help

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
Forum Header

TOPIC: Need Help

Re:Need Help 24 Jun 2012 09:31 #21267

  • andypugh
  • andypugh's Avatar
  • NOW ONLINE
  • Moderator
  • Posts: 4123
  • Thank you received: 141
  • Karma: 129
ricky_a wrote:
X axis moves 130 mm per revolution
Y axis moves 250 mm per revolution
Z axis moves 2 mm per revolution

What about on the drivers that I can manually switch between 400-51200

In stepconf wizard basic machine information, should I change anything there.

Taking the X-axis. In Stepconf set the motor to 200 steps per rev, and the micro stepping to suit what the drives are set to.
For simplicity, set the pulleys to both the same size, for example 10:10.
For the lead screw pitch use 130.
That should be right.
The administrator has disabled public write access.

Re:Need Help 24 Jun 2012 11:08 #21270

  • BigJohnT
  • BigJohnT's Avatar
  • OFFLINE
  • Administrator
  • Posts: 4955
  • Thank you received: 86
  • Karma: 134
To start out I would set the micro stepping jumper to 2. See section 7.1 of your manual or here. Then set micro stepping to 2 in the stepconf and the rest Andy has pointed out for you.

John
The administrator has disabled public write access.

Re:Need Help 24 Jun 2012 11:41 #21272

  • ricky_a
  • ricky_a's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 63
  • Karma: 0
Now I understand it better, that I try
The administrator has disabled public write access.

Re:Need Help 24 Jun 2012 12:49 #21274

  • ricky_a
  • ricky_a's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 63
  • Karma: 0
I've tried, x and y axis running very slow and choppy. z axis running smoothly but slowly what should I change.
The administrator has disabled public write access.

Re:Need Help 24 Jun 2012 12:58 #21276

  • BigJohnT
  • BigJohnT's Avatar
  • OFFLINE
  • Administrator
  • Posts: 4955
  • Thank you received: 86
  • Karma: 134
Did you verify that a move of 1mm or 10mm actually moves the commanded distance? This will verify you have the scale for each axis set correctly.

How did you move the axis? Jog key? Rapid move in the MDI tab?

John
The administrator has disabled public write access.

Re:Need Help 24 Jun 2012 13:09 #21277

  • ricky_a
  • ricky_a's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 63
  • Karma: 0
distance does not fit when I test in the axis test. I am moving axis, with the jog key.
The administrator has disabled public write access.
Time to create page: 1.427 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.