hm2_bspi_setup_chan

NAME
SYNTAX
DESCRIPTION
RETURN VALUE
SEE ALSO

NAME

hm2_bspi_setup_chan − setup a Hostmot2 bspi channel

SYNTAX

int hm2_bspi_setup_chan(char *name, int chan, int cs, int bits, float mhz, int delay, int cpol, int cpha, int clear, int echo)

DESCRIPTION

hm2_bspi_setup_chan Setup the bspi channel "chan" on the bspi instance "name". "name" is a unique string given to each bspi channel during hostmot2 setup. The names of the available channels are printed to standard output during the driver loading process and take the form: hm2_<board name>.<board index>.bspi.<index> For example hm2_5i23.0.bspi.0 Channels are numbered 0 to 15. The value on the chip-select lines is set by cs and need not match the channel number. BSPI supports 4 chip select lines, so the valid range for cs is 0-15. "bits" sets the bit-length of the SPI packet. The maximum supported length is 64 bits but this will span two read FIFO entries and will need special handling. "mhz" sets the chip communication rate. The maximum value for this is half the FPGA base frequency, so for example with a 48MHz 5i23 the max SPI frequency is 24Mhz. Values in excess of the max supported will be silently rounded down. "delay" sets the chip select valid delay (in nS). "cpha" is the clock phase and "cpol" is the clock polarity (from the device datasheet). "clear" controls whether the frame clear bit is set after the 32 bit buffer transfer. This parameter should be set to 1 when the frame length is greater than 32 bits and the next data in the FIFO contains the other bits. "echo" is sense-inverted, it should be set to 1 for devices which do not return data (such
as DACs).

RETURN VALUE

Returns 0 on success and -1 on failure.

SEE ALSO

man hm2_bspi_setup_chan, man hm2_bspi_write_chan, man hm2_tram_add_bspi_frame man hm2_allocate_bspi_tram. See src/hal/drivers mesa_7i65.comp for an example usage.